Panic Bar and Exit Device Repair

Exit devices that stick, sag, won't latch or won't retract from the outside, repaired or replaced with commercial-grade hardware.

Locksmith servicing commercial door hardware

Hardware that has to work every time

A panic bar, also called a push bar or exit device, lets people leave a building with one push, without knowing how the lock works. That's exactly why a failing one matters. It's on the door people use in an emergency, and on the back door your staff uses fifty times a shift.

Signs your exit device needs attention

  • The latch doesn't catch, so the door won't stay closed or secure.
  • The bar needs a hard push, sticks halfway, or doesn't spring back.
  • The outside trim or key no longer pulls the latch back.
  • The bar sags, rattles, or has come loose from the door.
  • On double doors, the top or bottom rod doesn't engage.
  • The door and the closer fight each other, so the door bounces back open.

Types of exit devices we service

TypeWhere you see it
Rim exit deviceSingle doors: back doors, stairwells, loading areas
Mortise exit deviceHigher-use entrances where the lock sits inside the door
Surface vertical rodDouble doors with rods to the top and bottom of the frame
Concealed vertical rodDouble doors with rods hidden inside the door
Alarmed exit deviceEmergency-only doors that sound when pushed
Electrified exit deviceDoors tied to access control or remote release

Repair or replace

Most exit device problems are fixed with an adjustment, new springs, a new latch bolt, or a replacement trim. Vertical rod devices often just need the rods and latches realigned after the door has settled. When a device is worn beyond repair, we replace it with commercial-grade hardware that fits the door's existing holes wherever possible, so you're not paying to patch and repaint.

Keeping egress clear

Exit doors are part of a building's life safety plan. When we work on them, we keep them operating the way they're required to: opening from the inside with one motion, with no extra locks, chains or bars blocking the way out. If we find a door that's been chained or padlocked, we'll point it out.

Dogging and after-hours security

Many exit devices can be "dogged," which holds the latch retracted so the door works like a push-pull door during business hours. If your staff dogs the door during the day, make sure it's undogged at closing, or the door won't lock. We can show your team how, and add a cylinder dogging feature so only key holders can change it.

Maintenance that keeps exit doors working

Exit devices on busy doors last much longer with a little attention. Between service visits, a building manager can watch for these:

  • Loose mounting screws on the bar or the end cap
  • A latch that has to be pushed or lifted to catch the strike
  • Rods on double doors that no longer drop into the floor or top strike
  • Outside trim that doesn't pull the latch back when the key is turned
  • Unusual noise or grinding when the bar is pushed

Catching these early usually means an adjustment instead of a replacement. For buildings with several exit doors, a yearly check of every device and closer is a simple way to avoid a door that fails when it matters most.

Common questions

Can you add a key cylinder to the outside of our exit door?

Usually. Most exit devices accept an outside trim with a key cylinder or lever, so the door can be opened from outside by authorized people.

Our double doors won't stay locked. What's wrong?

On vertical rod devices, the top or bottom latch often stops engaging as the doors settle. Adjusting the rods and strikes usually fixes it.

Do you also repair the door closer?

Yes. A closer that's out of adjustment is a common reason exit doors don't latch. See door closer repair.

Need a Locksmith Anywhere in Southern New Hampshire?

From Nashua and Manchester to Salem, Exeter and Hampton, call and tell us what's going on. We'll take it from there.

(603) 602-7593

Open 24/7, every day of the week.

Call (603) 602-7593