What a door closer does
A closer controls the door from the moment someone lets go. It swings the door back toward the frame, slows it down before it reaches the jamb, and gives it a final push so the latch catches. When any of those steps is off, you notice: the door slams, drifts open in the wind, or stops an inch short so the lock never engages.
Signs your closer needs attention
- The door swings shut too hard and slams into the frame.
- It closes too slowly, or stops before latching.
- There's oil on the closer body or the floor beneath it.
- The arm is bent, loose or disconnected.
- The door is hard to open, especially for children or older visitors.
- It works in summer but drags or slams once the weather turns cold.
Why winter makes it worse
Most closers are hydraulic. The fluid inside thickens in the cold, so a closer adjusted on a warm day can become slow and stubborn in January, while one adjusted in winter may slam in July. Exterior doors in New Hampshire need closers adjusted for the season, or a closer with fluid rated for wide temperature swings.
Adjustments we make
| Setting | What it controls |
|---|---|
| Sweep speed | The speed of the door through most of its swing |
| Latch speed | The final few inches, where the latch has to catch |
| Backcheck | Cushioning when the door is thrown open, so it doesn't hit the wall |
| Spring power | How much force the door closes with, matched to the door and wind load |
When to replace
If the closer is leaking oil, it can't be repaired. The seals have failed and the closer will only get worse. We replace it with a commercial closer sized for the door's width, weight and location, and mount it in the existing holes whenever possible.
Closers and access control
On doors with access control or electrified locks, the closer is part of the security system. If it doesn't pull the door fully shut, the lock can't do its job. When an access-controlled door "won't lock," the closer is one of the first things we check. The same goes for doors with panic bars.
Where we install closers
- Office and retail entrances
- Apartment and condo building entries and hallway doors
- Restaurant back doors and kitchen doors
- Fire-rated stairwell and corridor doors
- Gates and vestibule doors
Choosing the right closer
When a closer needs replacing, size and mounting matter. A closer that's too weak won't latch a heavy door against wind, and one that's too strong makes the door hard to open. We look at:
- The door's width, weight and whether it's an exterior door
- Whether the closer mounts on the push side, the pull side or the top jamb
- Hold-open needs, such as a stockroom door that should stay open during deliveries
- Accessibility, since many commercial doors must open with limited force
Heavy-duty commercial closers can last for many years with an occasional adjustment. If your building has several doors with aging closers, replacing them together gives you matching hardware and a consistent feel at every entrance.
Common questions
Can a leaking door closer be refilled?
No. Once a closer leaks, the internal seals have failed. It needs to be replaced.
Our door is too heavy to open. Can you fix that?
Usually. Reducing the spring power makes the door easier to open, as long as it still closes and latches reliably.
Do fire doors need closers?
Fire-rated doors are required to close and latch on their own, which is why a working closer on those doors is so important.

