Ignition Repair

Key won't turn, won't come out, or broke off inside the ignition? We repair and replace ignition cylinders at your vehicle and get you driving again.

Locksmith working on a car for a driver

Common ignition problems

What you noticeUsual cause
Key won't turn at allSteering wheel lock engaged, a worn key, or worn wafers in the cylinder
Key turns only with jigglingWorn key cuts or worn cylinder wafers
Key is stuck in the ignitionShifter not fully in Park, a bent key, or a failed cylinder
Key broke off insideWorn or cracked key under twisting force
Key turns freely but nothing happensBroken tailpiece or a fault behind the cylinder

Try these first

  • Steering lock: turn the steering wheel gently left and right while turning the key. If the wheel was turned when the car was shut off, the lock pin may be under tension.
  • Shifter: make sure an automatic is fully in Park. Shift into Neutral and back to Park.
  • Spare key: if the spare turns smoothly, the problem is your key, not the ignition.
  • Don't force it. Pliers and hard twisting are how keys break inside the cylinder.

Repair, rekey or replace

Many ignition problems are actually key problems. A key worn down over years of use no longer lifts the wafers to the right height, so the cylinder binds. Cutting a fresh key to factory specifications often fixes the problem for good. See car key replacement.

When the cylinder itself is worn or damaged, we can repair it, replace it with a new cylinder, and in many cases key the new cylinder to match your existing door key, so you don't need two keys.

Broken key in the ignition

If the key snapped off inside, don't try to start the car with the remaining piece. We extract the broken part, check the cylinder for damage, and cut and program a new key. Read more about broken key extraction.

After an attempted theft

A damaged ignition after a theft attempt usually needs a replacement cylinder. We'll inspect the column for damage, install a new cylinder and program keys to match. Keep your police report number for the insurance claim.

Push-to-start vehicles

Push-button ignitions don't have a cylinder, but they can still fail to start when the smart key isn't detected. Most of the time that's a weak fob battery or a smart key that needs reprogramming. See key fob programming.

Older vehicles and trucks

Ignition problems are most common in vehicles with high miles and in trucks and vans used for work, where keys are turned many times a day and often carry a heavy key ring. That extra weight pulls on the ignition cylinder every time the vehicle moves, wearing the wafers out early. If your work truck's key is starting to stick, take the other keys off the ring and keep only the vehicle key on it.

What we check on an ignition call

  • Whether the key itself is worn, bent or cracked
  • Whether a spare key turns smoothly
  • The steering lock and the shifter position
  • The condition of the cylinder and its wafers
  • Signs of a theft attempt or a forced cylinder
  • Whether the transponder chip is being read

That sequence tells us whether you need a new key, a repaired cylinder, or a full replacement, so you only pay for the fix that's actually needed.

Common questions

Can you fix my ignition without towing the car?

In most cases, yes. We repair and replace ignition cylinders on site.

Will a new ignition need a new key?

Often we can key the new ignition to your existing key. If not, we cut and program new keys at the same time.

Is it safe to keep driving with a sticky ignition?

It's a warning sign. A key that binds can break, or the cylinder can fail with the key stuck, so it's worth fixing before it leaves you stranded.

Need a Locksmith Anywhere in Southern New Hampshire?

From Nashua and Manchester to Salem, Exeter and Hampton, call and tell us what's going on. We'll take it from there.

(603) 602-7593

Open 24/7, every day of the week.

Call (603) 602-7593